To clean pebble dash, treat the wall rather than blast it: apply a masonry-safe algae and mould treatment at low pressure, give it time to work, then rinse gently and brush only where dirt clings. The stones are bedded into a thin coat of render, so a high pressure jet can knock them loose and drive water behind the finish. White and painted pebble dash need the same gentle approach, and anything above the ground floor is a job for a professional.
Pebble dash, often written pebbledash, is render with small stones pressed into the surface while it was still wet. The rough texture makes it hard-wearing, but every stone has a ledge where dirt, spores and moisture settle. This guide covers why it discolours, how to clean it yourself and when to call us.
Why pebble dash goes green, grey and black
The surface of pebble dash is all edges. Each stone sticks out of the render and leaves a small shelf above and below it, and those shelves collect windblown dirt, pollen and the spores of algae and lichen. Because the texture stays damp for longer than a smooth wall, growth gets going quickly, especially on elevations that see little sun or sit close to trees.
Green is usually algae. Grey and black patches can be lichen, mould or ordinary grime, and dark vertical streaks often show where rainwater runs off a sill or an overflowing gutter in the same line every time it rains. If they start under the roofline, check the gutters first. Our guide to black streaks on render explains the usual causes in more detail.
How to clean pebble dash yourself
For a ground-floor wall or a small area you can reach safely from the ground, a careful DIY clean is realistic. Pick a dry, overcast day with no rain forecast, so the treatment is neither washed off nor dried out by strong sun.
Prepare and treat
Wet the planting below and cover anything delicate, then cover air bricks and vents if your product label advises it. Apply a masonry-safe algae and mould remover with a garden pump sprayer, working from the bottom up so it does not run in streaks over dry render, and leave it for the time given on the label.
Rinse without force
Rinse with a hose, or with a pressure washer turned right down and held well back, so the water flows over the stones rather than hitting them. Where dirt clings, a soft brush on a pole works it out of the texture without dislodging anything. Avoid wire brushes and stiff scrubbing, which knock stones loose and scratch the render between them.
Judge it once dry
Algae treatments often keep working after the rinse, so faint staining can fade over the following weeks of rain. If the wall is still patchy after that, a second application or a professional clean is the next step.
What not to do
The common mistake is turning a jet wash up to full. Pebble dash is only as strong as the thin coat holding the stones, and high pressure chips stones out, leaves bald patches, widens hairline cracks and pushes water into the wall, where it can later show up inside as damp. Our guide can you pressure wash render explains why the same applies to other finishes.
Neat bleach is the other shortcut to avoid. It lightens growth quickly, but the effect does not last, runoff can scorch borders and lawns, and it can mark coloured or painted walls. A product made for exterior masonry, used at the dilution on the label, is kinder to the wall and the garden. The differences are covered in bleach versus biocide.
White, painted and cracked pebble dash
White pebble dash shows every mark, so it is tempting to scrub harder. Resist that: treat, wait, rinse and repeat rather than adding force. Painted pebble dash is more delicate again, because any loose or flaking paint will lift under pressure and leave the wall looking worse than before. If you plan to repaint, clean first and let the wall dry thoroughly; our guide to cleaning render before painting covers the timing.
Cleaning will not fix cracks, hollow-sounding patches or areas where stones have already fallen away. Those need a plasterer or renderer, and it is worth having them looked at before the wall is washed, because water can find its way into an open crack.
When to call a professional
Pebble dash above the ground floor, gable ends and walls over a conservatory are better left to a professional. Our render cleaning service uses soft washing and steam: a dilute solution applied at low pressure so it works on the growth itself, with steam where heat helps release stubborn deposits. We are trained in biocide use and fully insured, and we consider planting, paths and drains before any solution goes on.
We do not publish a price list because walls vary so much. Tell us roughly how much pebble dash there is, how high it goes and send a photo if you can, and we will quote. You can request a quote or call 07501060609. We cover the North East from our base in Washington.
Want a professional to handle it?
Need a hand with your property?
Quotes across the North East. Call us or request a quote.
Call 07501060609We cover the North East only – up to 45 miles from Washington (NE37): Newcastle, Sunderland, Durham, Gateshead, South Shields, Middlesbrough and surrounding areas.
Get Your Quote!
Enter your details below and one of our experts will be in touch to discuss the work needed and give you your quote.
We cover the North East only – up to 45 miles from Washington (NE37): Newcastle, Sunderland, Durham, Gateshead, South Shields, Middlesbrough and surrounding areas.
Frequently asked questions
Related guides
More on this topic: render, brick and walls guides and service
